Filter
Top Products
Front bezel
This section describes how to remove and install the front bezel.
Removing the front bezel
1. Disconnect power from the workstation (see Predisassembly procedures on page 73).
2. Remove the side access panel (see
Removing the side access panel on page 75).
3. Remove the right side panel (see
Removing the right side panel on page 80).
4. Remove the four T-15 Torx screws
, and then remove the bezel from the chassis as shown in
the following figure
2
.
Figure 5-15 Removing the front bezel
Installing the front bezel
To install the front bezel, position the bezel on the chassis and install the screws.
ENWW Removing and installing components 85