Filter
Top Products
Front panel I/O cable assembly
This section describes how to remove and install a front panel I/O cable assembly.
Removing the front panel I/O cable assembly
1. Disconnect power from the workstation (seePredisassembly procedures on page 73 ).
2. Remove the side access panel (see
Removing the side access panel on page 75).
3. Remove the expansion card support. (see
Removing the expansion card support on page 77).
4. Remove the expansion card guide/front fan holder (see
Removing the expansion card guide/front
fan holder on page 126).
5. Remove the right side panel (see
Removing the right side panel on page 80).
6. Remove the front bezel (see
Removing the front bezel on page 85).
7. Disconnect the front panel I/O cable assembly cables from the system board as shown in the
following figure.
Figure 5-16 Disconnecting the front panel I/O cable assembly cables
Item Description
1 Front audio
2 Front 1394a
3 Front USB
86 Chapter 5 Replacing components ENWW