Filter
Top Products
Optical disk drive
This section describes how to remove and install an optical disk drive.
Removing an optical disk drive from the optical drive bay
1. Disconnect power from the workstation (see Predisassembly procedures on page 73).
2. Remove the side access panel (see
Removing the side access panel on page 75).
3. Remove the airflow guide (see
Removing the airflow guide on page 76).
4. Remove the expansion card support (see
Removing the expansion card support on page 77).
5. Disconnect the power
and data
2
cables from the optical disk drive as shown in the following
figure.
Figure 5-24 Disconnecting the optical disk drive cables
94 Chapter 5 Replacing components ENWW