Filter
Top Products
2-36 Removal and Replacement HP Omnibook XE3 (Technology Codes GE and GD)
6.
Disconnect the cable from the headphone PCA, and remove the PCA.
7.
Remove the CPU standoffs.
8.
Remove the CD/DVD drive support from near the right rear corner of the motherboard.
9.
Lift the front edge of the motherboard slightly, then lift the motherboard forward and out of the
bottom case.
Figure 2-24. Removing the Motherboard
Reassembly Procedure
•
When reinstalling the motherboard, see “Reinstalling the Motherboard“ on page 2-37.
•
When reinstalling the bottom case, see “Replacing the Bottom Case“ on page 2-38.
Screw,
M2.5x5 mm
(
1
)
Screw,
M2.5x5 mm
(
1
)
Standoff screws, 5 mm (6)
CPU standoff
screws, 5 mm (4)
Headphone
PCA
CD/DVD support