Filter
Top Products
3-30 Troubleshooting and Diagnostics HP Omnibook XE3 (Technology Codes GE and GD)
Message Description
02F5: DMA Test Failed
ServerBIOS2 test error: Cannot write to extended DMA (Direct Memory Access) registers.
02F6: Software NMI Failed
ServerBIOS2 test error: Cannot generate software NMI (Non-Maskable Interrupt).
02F7: Fail-Safe Timer NMI Failed
ServerBIOS2 test error: Fail-Safe Timer takes too long.
device
Address Conflict
Address conflict for specified device.
Allocation Error for:
device
Resolve the resource conflict for the specified device.
CD ROM Drive
CD ROM Drive identified.
Entering SETUP ...
Starting the BIOS Setup program.
Failing Bits:
nnnn
The hex number
nnnn
is a map of the bits at the RAM address that failed the memory test.
Each 1 in the map indicates a failed bit. See errors 230, 231, or 232 above for offset address
of the failure in System, Extended, or Shadow memory.
Fixed Disk
n
Fixed disk
n
(0–3) identified.
Invalid System Configuration Data
Problem with NVRAM (CMOS) data.
I/O device IRQ conflict
An I/O device has an IRQ conflict.
PS/2 Mouse Boot Summary Screen:
A
PS/2 mouse is installed.
nnnn
kB Extended RAM Passed
Where
nnnn
is the amount (in KB) of SDRAM successfully tested.
nnnn
Cache SRAM Passed
Where
nnnn
is the amount (in KB) of system cache successfully tested.
nnnn
kB Shadow RAM Passed
Where
nnnn
is the amount (in KB) of shadow RAM successfully tested.
nnnn
kB System RAM Passed
Where
nnnn
is the amount (in KB) of system RAM successfully tested.
Operating system not found
No operating system was found on drive A: or drive C:. Enter BIOS Setup and see if the hard
disk and drive A: are properly identified.
Parity Check 1
nnnn
A parity error was found in the system bus. (Parity is a method for checking errors in binary
data: a parity error indicates that some data has been corrupted.) The BIOS attempts to
locate the address and display it on the screen, and otherwise displays ????.
Parity Check 2
nnnn
A parity error was found in the I/O bus. The BIOS attempts to locate the address and display
it on the screen, and otherwise displays ????.
Press <F1> to resume, <F2> to Setup, <F3> for previous
Displayed after any recoverable error message. Press <F1> to resume the boot process, or
<F2> to enter BIOS Setup and change the settings. Press <F3> to display the previous
screen (usually an initialization error of an Option ROM, such as an add-on card). Write down
and follow the information shown on the screen.
Press <F2> to enter Setup
Optional message displayed during POST.
PS/2 Mouse:
A
PS/2 mouse was identified.
System BIOS shadowed
System BIOS was copied to shadow RAM.
UMB upper limit segment address:
nnnn
Displays the address
nnnn
of the upper limit of Upper Memory Blocks, indicating released
segments of the BIOS that can be reclaimed by a virtual memory manager.
Video BIOS shadowed
Video BIOS was copied to shadow RAM.