Filter
Top Products
Chapter 5 Problem Solving 285
Correcting Output Quality Problems
General repeated
stapler jam problems.
! Check to see that the job to be stapled is less than 2 mm
thick.
! Stapler may have some trapped staple wires that are
obstructing the magazine. Remove loose staples and
paper dust from the inside of the stapler (page 222
).
Printer does not
recognize the 5-bin
Mailbox with Stapler.
! Make sure that the 5-bin Mailbox with Stapler has been
configured in the printer driver. See page 62
for more
information on accessing the printer driver.
! Make sure that the cable from the 5-bin Mailbox with
Stapler is plugged into the printer C-link connector. If not,
turn the printer off and plug the cable into the C-link
connector, then turn the printer back on. See page 292
for
cabling configurations.
! Make sure that all bins are properly installed.
! If the printer still does not recognize the 5-bin Mailbox with
Stapler, contact your dealer or authorized HP service
provider.
Problems with the Optional 5-bin Mailbox with Stapler (continued)
Situation Solution