Filter
Top Products
Chapter 5 Problem Solving 304
Correcting Output Quality Problems
The printer prints only
part of a page or
document.
The connection has been broken during transmission. If you
move the portable device during transmission, the
connection can be broken. IRDA-compliant devices are
designed to recover from temporary connection interruptions.
You have up to 40 seconds to re-establish the connection
(depending on the portable device being used).
The print job has been
properly sent, but the
printer will not print.
If the connection is broken before the entire print job has
been transmitted to the printer (printing has not yet started),
the printer may not print any of the job. Press C
ANCEL
J
OB
to
clear the printer’s memory. Then, reposition the portable
device within the range of operation described in Printing a
Job on page 182, and print the job again.
The FIR status indicator
turns off during
transmission.
The connection might have been broken. Press C
ANCEL
J
OB
to clear the printer’s memory. Then, reposition the portable
device within the range of operation described in Printing a
Job on page 182, and print the job again.
PS print job will not
print.
Check the configuration in the PostScript Tab of Windows:
check that Protocol is set to AppleTalk and Binary Data is not
selected.
HP Fast InfraRed Connect Problems (continued)
Situation Solution