Filter
Top Products
3. Adjust the media guides until they are snug against the media.
4. Use the alphanumeric buttons on the control panel to dial the number.
-or-
If the fax number you are calling has been assigned to a one-touch key, press that key.
-or-
If the fax number you are calling has a speed dial or group-dial entry, press Phone Book, use the
alphanumeric buttons to specify the speed dial or group-dial entry, and then press OK.
5. On the control panel, press Start Fax. The product starts the fax job.
Fax a two-sided original
To fax a two-sided document, use the scanner glass. See Fax from the flatbed scanner on page 118.
Manual dial faxing
Usually, the product dials after you press Start Fax. At times, however, you might want the product to
dial each number as you press it. For example, if you are charging your fax call to a calling card, you
might need to dial the fax number, wait for the acceptance tone of your telephone company, and then
dial the calling card number. When dialing internationally, you might need to dial part of the number and
then listen for dial tones before continuing to dial.
Dial manually with the automatic document feeder (ADF)
1. Load the document into the automatic document feeder (ADF) input tray.
2. On the control panel, press Start Fax.
3. Begin dialing.
NOTE: The product dials the number as you press each digit. This allows you to wait for pauses,
dial tones, international-access tones, or calling-card-acceptance tones before continuing to dial.
Dial manually with the flatbed scanner
1. On the control panel, press Start Fax.
The control-panel display shows the following message: Send from glass? 1=Yes 2=No.
2. Press 1 to select Yes. The control-panel display shows the following message: Load page: X
Press OK, where X is the page number.
3. Scan a page into memory by placing the sheet print-side-down on the flatbed scanner and pressing
OK. After scanning the page, the product control-panel display shows the following message:
Another page? 1=Yes 2=No.
120 Chapter 10 Fax ENWW