Filter
Top Products
8 - 37
Processing
The Processing tab contains a user configurable key delay that applies to scanned bar codes as they are input when Remote
Desktop is the application with the input focus.
Note: Settings on this panel have no effect when RFTerm is the application with the input focus.
Enable buffered key output
Enabled (checked) and dimmed. The user cannot change this setting.
Same buffer limit
Default is 32 ms. Raise or lower this value as desired.
Delay between (key) buffers
Specifies the number of milliseconds to delay after each character in the scanned bar code is processed as a keystroke.
This value may need to be adjusted depending on the network traffic in the environment. The default value is 75 ms. Valid
range is from 0 to 9999. A zero value is No Delay between characters.
Enable only in Remote Desktop
The delay specified in Wait between (key) buffers is applied only when Remote Desktop is enabled and is the application with
the input focus. When disabled, all keystrokes are delayed by the number of milliseconds specified in Wait between (key) buf-
fers.
Setting Default
Enable buffered key output Enabled and dimmed
Same buffer limit (characters) 32
Delay between buffers 75 ms
Only in Remote Desktop Enabled