Filter
Top Products
3 - 6
Display
The touch screen display is an active color LCD unit capable of supporting VGA graphics modes. Display size is 240 x 320
pixels in portrait orientation. The covering is designed to resist stains. The touch screen allows signature capture and touch
input. A pen stylus is included. The touch screen responds to an actuation force (touch) of 4 oz. of pressure (or greater).
The color display is optimized for indoor lighting. The display is black when the device is in Suspend Mode or when both
batteries have expired and the unit is Off.
Display Backlight Timer
When the Backlight Timer expires the display backlight is turned off. The default value for the battery power timer is 3
seconds. The default value for the external power timer is “never” and the check box is blank. The backlight timer dims
the backlight on the touch screen and the keypad at the end of the specified time. When the display wakes up, the
Backlight timer begins the countdown again. The keypad backlight can be synchronized with the display backlight
activity.
Status LEDs
• The MX7 Tecton does not have a Bluetooth managed LED. Bluetooth activity indicators are located in the taskbar.
• System Status LED is located at the top left of the keypad, above the Scan button.
• The Scan Status LED is located below the keypad.
• The Alpha Mode LED is located below the F4 key on the 32-key keypad (Numeric-Alpha keypad).
Cold Storage Configuration
• MX7 Tecton 1250mAh Cold Storage battery has a blue label.
• Snowflake decal above the MX7 Tecton keypad.
• Heating element visible on the touch screen and the scan aperture.
Cold storage battery is recharged in the MX7 Tecton Battery Charger, MX7 Tecton Desk Cradle and when in an MX7 Tecton
attached to an external power source (e.g., AC adapter).
The Cold Storage version is designed to operate normally when reading bar codes and moving from, and into, cold storage
warehouses, freezers and vehicles where the temperatures may vary between -30°C and 5°C (-22°F and 41°F).
Cold Storage Battery
There is no change in the way the Cold Storage battery is inserted into and removed from the MX7 Tecton battery well.
Battery Life – minimum 2.5 hours while the unit is roaming, powered on with ambient temperature -10°C (14°F) or
above, Display backlight turned on, Keypad LED backlight on, radio connected to Access Point, and scanner decoding
bar codes.
LED Color - Activity Indicates ...
System Status Red - Blinking Power fail. Replace the main battery with a fully charged main battery.
Or
Connect the MX7 Tecton to external AC power then replace the main battery with a fully
charged main battery.
Red - Steady Main Battery Low. If the main battery is not replaced with a fully charged battery before
the main battery fails, the MX7 Tecton is turned Off.
Green - Blinking Display Off. No user intervention required.
No Color MX7 Tecton is either full on - with the display on (backlights may be dimmed when the
status LED has no color) or in Suspend - with the display off.
Scan Status Green - Steady Good scan.
Red – Steady Scan in progress.
No color Integrated Scanner / Imager ready for use.
Amber - Steady Bar code decoder engine is storing changed parameters.
Alpha Mode
(Alph LED)
Green - Steady MX7 Tecton 32-key is in Alpha character input mode.
No color MX7 Tecton 32-key is in Numeric key input mode.