Filter
Top Products
14 - 6
Top View
Desktop Mounting Footprint
1. Front
2. Table Mounting Hole Guides
3. Back
Bolts, washers, screws, screwdriver or wrench needed when attaching the MX7 Tecton desktop cradle to a protected flat
surface are not supplied by Honeywell.
Periodically check the table mounting hardware and re-tighten if necessary. Table mounting hardware can be finger-
tightened.
Note: Do not over-tighten the table mounting hardware. If the cradle is cracked, it must be replaced before being placed
into service. Contact Technical Assistance (page 16-1) for help.
1. Power Supply Connector
2. Spare Battery Charging Bay
3. Spare Battery Charging Terminals
4. Spare Battery Latch
5. Spare Battery
6. Table Mounting Holes
7. Cradle Connector
8. Docking Bay Adapter Cup
9. Docking Bay Adapter Cup Mounting Hole
10. Desktop Cradle Label
11. Serial Interface Connector
12. I/O Connector