Filter
Top Products
14 - 36
Removing the MX7 Tecton from a Powered Vehicle Cradle
1. Push the top of the Retainer up and back until the MX7 Tecton is released from the Retainer latches and the charging
pocket swings forward.
2. Pull the MX7 Tecton up and out of the vehicle cradle pocket, disconnecting the MX7 Tecton from the charge/
communication port at the base of the docking bay. The Docked LED turns off.
Powered Vehicle Cradle Help
The following is intended as an aid in determining whether the MX7 Tecton or the vehicle mounted cradle may be
malfunctioning.
Problem Cause Solution
MX7 Tecton docked in
cradle but cannot work
with accessory cables
connected to cradle.
MX7 Tecton not fully seated in cradle.
There are foreign objects inside
docking bay or cable connectors
Reseat the MX7 Tecton fully into the docking bay.
Remove the foreign objects and reseat the MX7
Tecton in the docking bay.
MX7 Tecton docked in
cradle but Docked LED
does not light up.
MX7 Tecton not fully docked.
Power supply not connected.
Check the docking bay is clear of foreign objects
and reseat the MX7 Tecton fully into the docking
bay.
Check that power is connected to the Power Port
at the rear of the cradle.