HUAWEI MC509 CDMA LGA Module
AT Command Interface Specification
Wakeup Commands
Issue 01 (2011-08-26)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
128
12 Wakeup Commands
12.1 ^WAKEUPCFG -Wakeup Function Configuration
12.1.1 Command Syntax
Command
Possible response(s)
^WAKEUPCFG=<n>[,
<channel>[,<source>]]
<CR><LF>OK<CR><LF>
Errors about MT:
<CR><LF>+CME ERROR:<err><CR><LF>
^WAKEUPCFG?
<CR><LF>^WAKEUPCFG:
<n>,<channel>,<source><CR><LF><CR><LF>OK<CR>
<LF>
^WAKEUPCFG=?
<CR><LF>^WAKEUPCFG: (list of supported <n>s),(list of
<channel>s),(list of supported <source>s)
<CR><LF><CR><LF>OK<CR><LF>
12.1.2 Description
This command is used to configure module‟s wakeup function by host, including the
hardware interfaces supported, and the supported remote-wakeup sources.
12.1.3 Defined Values
<n> The status of wakeup function
0: Turn off the wakeup function;
1 : Turn on the wakeup function (Default);
<channel> Option of hardware interfaces that support wakeup with length of 1 byte.
The supported hardware interfaces are defined with 8-bit mask. Every single bit
represents the status of one kind of hardware interface. „1‟ represents TURN ON and
„0‟ represents TURN OFF. Details are defined as following table: