HUAWEI MC509 CDMA LGA Module
AT Command Interface Specification
GPS Commands
Issue 01 (2011-08-26)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
134
14 GPS Commands
14.1 ^WPDOM–Command for Setting Operation Mode
14.1.1 Syntax
Command
Possible Response(s)
^WPDOM=<mode>
<CR><LF>OK<CR><LF>
Error:
<CR><LF>+CME ERROR: <err><CR><LF>
^WPDOM?
<CR><LF>^WPDOM: <mode><CR><LF>
<CR><LF>OK<CR><LF>
^WPDOM=?
<CR><LF>^WPDOM: (list of supported <mode>s)
<CR><LF>
<CR><LF>OK<CR><LF>
14.1.2 Interface Description
This command is used to set the position operation mode. Read command can
queries current operation mode, Test command returns supported operation mode.
SET command can only be used before position session beginning or after end, can‟t
be used during positioning, or will be error.
14.1.3 Parameter Description
<mode>: operation mode, default value is 0, no storing at power down
0: standalone only mode,no network assistance is required, and the MS can be
in or out of network coverage.
1: network only mode,MS operates in MS-assisted position calculation mode
only, MS communications with AGPS server for every position fix, and every fix
is calculated by AGPS server. Both PDE/PDM access and network coverage are
required for this mode of operation. If this mode failed, it‟ll switch to Cell-ID mode.