Filter
Top Products
HUAWEI MC509 CDMA LGA Module
AT Command Interface Specification
Wakeup Commands
Issue 01 (2011-08-26)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
130
12.2 ^CURC -Unsolicited report control command
12.2.1 Command Syntax
Command
Possible response(s)
^CURC=<mode>
<CR><LF>OK<CR><LF>
^CURC?
<CR><LF>^CURC:<mode><CR><LF>
<CR><LF>OK<CR><LF>
^CURC=?
<CR><LF>^CURC: (list of supported
<mode>s)<CR><LF>
<CR><LF>OK<CR><LF>
12.2.2 Interface Description
The SET command is used to set mode value to open or close unsolicited reports.
The unsolicited reports it can control are listed below: ：^MODE, ^SIMST ,^CRSSI,
^HDRSSI, ^RSSILVL,^HRSSILVL. The unsolicited reports are closed if the mode
value is set to 0 and the unsolicited reports are open if the mode value is set to 1.
The default value of mode is set to 1. So, “^CURC=0” should be executed if all the
unsolicited reports need to be closed.
The READ command returns the current mode value.
The TEST command returns the value range it supports.
12.2.3 Defined Values
<mode>:
0 the unsolicited reports closed
1 the unsolicited reports open (default value)
2 （not support now）