Filter
Top Products
Chapter 6 HPSS Configuration
318 September 2002 HPSS Installation Guide
Release 4.5, Revision 2
6.7.3 Configure the Classes of Service
Class of Service (COS) information must be created for each class of service that is to be supported
by the HPSS system. A COS can be created using the HPSS Class of Service window. After the
configuration entry is created, it can be viewed, updated, or deleted through the same window.
From the HPSS Health and Status window (shown in Figure 6-1), click on the Admin menu, select
the Configure HPSS option and click on the Classes of Service option.
The Class of Service Configuration window will be displayed as shown in Figure 6-18. The fields
are displayed with default values for a new class of service. If the default data is not desired, change
the fields with the desired values. Click on the Add button to create the configuration entry.
To update an existing class of service, select the Load Existing button on the Class of Service
Configuration window and select the desired class of service from the popup list. The window will
be refreshed with the configured data. Aftermodifying the data, click onthe Update button to write
the changes to the SFS file. Refer to Section 3.11.3: Changing Class of Service Definition (page 80) in
the HPSS Management Guide for more guidelines on changing a class of service configuration.
To delete an existing class of service, select the Load Existing button on the Class of Service
Configuration window and select the desired class of service from the popup list. The window will
be refreshed with the configured data. Click on the Delete button to delete the class of service. Refer
to Section 3.12.3: Deleting Class of Service Definition (page 82) in the HPSS Management Guide for
more guideline on deleting a class of service configuration.
Refer to the window’s help file for more information on the individual fields and buttons as well as
the supported operations available from the window.