Filter
Top Products
Chapter 6 HPSS Configuration
HPSS Installation Guide September 2002 403
Release 4.5, Revision 2
Figure 6-42 HPSS Devices and Drives Window
To configure a new device and drive, click on the Add New... button on the HPSS Devices and
Drives window. The Mover Device and PVL Drive Configuration window will be displayed as
shown in Figure 6-44 with default values for a new tape device/drive. If a disk device/drive is
desired, click the Disk button to display the default disk data (as shown in Figure 6-43) before
modifying any other fields. If the default data is not desired, changethe field withthe desired value.
Click on the Add button to create the configuration entry.
To update an existing device and drive, select the desired device and drive entry on the HPSS
Devices andDrives window and click on the Configure...button. The Mover Device and PVL Drive
Configuration window will be displayed with the configured data. After modifying the
configuration, click on the Update button to write the changes to the appropriate SFS file.
To delete an existing device and drive, select the desired device and drive on the HPSS Devices and
Drives window and click on the Configure... button. The Mover Device and PVL Drive
Configuration window will be displayed with the configured data. Click on the Delete button to
delete the configuration entry.
Refer to the window’s help file for more information on the individual fields and buttons as well as
the supported operations available from the window.