Filter
Top Products
Appendix G High Availability
HPSS Installation Guide September 2002 551
Release 4.5, Revision 2
Figure H-3 Adding Cluster Nodes
G.4.3.3 Define the networks
The SMIT path for configuring each network (ethernet and RS232) is the same
% smitty hacmp
Cluster Configuration
-> Cluster Topology
-> Configure Networds
-> Add an Network
At this point, you will be offered two options, IP-based Network and Non IP-based
Network.
Choose IP-based Network to configure your ethernet network. When this choice is entered,
SMITTY will query your machine for IP-based networks and provide you with a list of networks.
There will likely be only one choice, but make sure that the network you choose corresponds to the
IP addresses for your service, boot, and standby adapters.