Filter
Top Products
Chapter 6 HPSS Configuration
406 September 2002 HPSS Installation Guide
Release 4.5, Revision 2
Device /Drive Type The type of device over
which data will move.
Any valid type from the pop-up list. Default Tape
or Default
Disk, based
on Tape/Disk
toggle
buttons.
Mover The name of the MVR that
controls the device.
Any configured MVR name from
the pop-up list.
First
configured
MVR name
found in the
SFS file.
Advice: There is a maximum of 64 devices that can be configured for a Mover.
PVR The name of the PVR that
handles the removable
media operations for the
drive.
Any configured PVR name from
the pop-up list.
First
configured
PVR name
found in the
SFS file.
Advice: This field is meaningful for tape devices only.
Mounted Volume The 8-character name of
the volume mounted on
the disk drive, if any.
Valid 8-character name assigned to
the disk volume.
None
Advice: This value is meaningful for disk devices only.
Bytes on Device The size of device in bytes. Any positive 64-bit integer value up
to the system-imposed maximum
device size.
None
Advice: This value is used for disk devices only. If it is modified after the mounted
disk volume has been imported into HPSS, the volume must be re-imported into
HPSS.
Note that the PV Size from Section 6.7 for the storage class must be less than or
equal to the value of Bytes on Device.
If the Starting Offset is non-zero, then the Bytes on Device value cannot be greater
than the actual size of the underlying device less the Starting Offset value.
Table 6-33 Device/Drive Configuration Variables (Continued)
Display Field Name Description Acceptable Values
Default
Value