Filter
Top Products
Chapter 6 HPSS Configuration
HPSS Installation Guide September 2002 341
Release 4.5, Revision 2
6.8.7 Migration Purge Server Specific Configuration
The Migration/Purge Serverspecific configuration entrycan be created using the Migration/Purge
Server Configuration window. After the configuration entry is created, it can be viewed, updated,
or deleted through the same window.
From the HPSS Health and Status window (shown in Figure 6-1), click on the Admin menu, select
the Configure HPSS option and click on the Servers option. The HPSS Servers window will be
displayed as shown in Figure 6-5.
Table 6-21 Metadata Monitor Configuration Variables
Display Field Name Description Acceptable Values
Default
Value
Server Name The descriptive name of
the MMON. This name is
copied over from the
MMON general
configuration entry.
This field cannot be modified. It is
displayed for reference only.
The selected
MMON
descriptive
name.
Server ID The UUID of the Metadata
Monitor. This ID is copied
over from the MMON
general configuration
entry.
The UUID of the MMON. This
field cannot be modified. It is
displayed for reference only.
Extracted
from the
MMON
general
configuration
entry.
SFS Volume Warning
Threshold
A percentage value that
indicates when warning
alarms should be issued.
The MMON will issue
warning alarms to SSM
when the space used by
any SFS volume reaches
this percentage.
Integer value between 1 and 100. 75
SFS Volume Critical
Threshold
A percentage value that
indicates when critical
alarms should be issued.
The MMON will issue
critical alarms to SSM
when the space used by
any SFS volume reaches
this percentage.
Integer value between 1 and 100. 90
SFS Update Interval An indication of how often
(in seconds) the SFS
server should be queried.
Integer value between 60 and 600. 300
SFS Name The name of the Encina
SFS server to monitor.
Valid DCE CDS name that refers to
a valid Encina SFS server.
/.:/encina/sfs/
hpss