Filter
Top Products
Peripheral SetupCBI/CGI Technical Reference
Chassis Plans 8-1
Chapter 8 Peripheral Setup
PERIPHERAL
SETUP
When you select Peripheral Setup from the AMIBIOS Setup Utility Main Menu, the
following Setup screen displays:
Peripheral Setup Screen
When you display the Peripheral Setup screen, the format is similar to the sample shown
above. The available values for each option are displayed on the right side of the screen
when you tab or arrow into the field.
_______________________________________________________________________
NOTE: The values on this screen do not necessarily reflect the values appropriate for
your SBC. Refer to the explanations below for specific instructions about entering
correct information.
_______________________________________________________________________
P
ERIPHERAL
SETUP OPTIONS
The descriptions for the system options listed below show the values as they appear if
you have not yet run Peripheral Setup. Once values have been defined, they display each
time Peripheral Setup is run.
The AMIBIOS allows automatic or manual setup of peripheral devices. The floppy
drive controller, serial port, parallel port and IDE controller options on the Peripheral
Setup screen can each be set to Auto, which causes AMIBIOS to configure the periph-
erals automatically as described under each heading below.
When you set these options to values other than Auto, the values you set up manually are
used by AMIBIOS when booting the system. AMIBIOS reports any I/O conflicts after
displaying the BIOS Configuration Summary screen.
AMIBIOS SETUP - PERIPHERAL SETUP
(C)1998 American Megatrends, Inc. All Rights Reserved
OnBoard FDC Auto
OnBoard Serial Port1 Auto
OnBoard Serial Port2 Auto
OnBoard Parallel Port Auto
Parallel Port Mode ECP
EPP Version N/A
Parallel Port IRQ Auto
Parallel Port DMA Channel Auto
OnBoard IDE Both
Available Options:
Auto
Disabled
Enabled
ESC:Exit
↑↓:Sel
PgUp/PgDn:Modify
F2/F3:Color