Filter
Top Products
Standard CMOS Setup CBI/CGI Technical Reference
Chassis Plans4-6
Available options are:
Off
On
Programmed I/O (PIO) Mode
IDE PIO mode programs timing cycles between the IDE drive and the programmable
IDE controller. As the PIO mode increases, the cycle time decreases.
Set the PIO Mode option to Auto to have AMIBIOS select the PIO mode used by the
IDE drive being configured. If you select a specific value for the PIO mode, you must
make absolutely certain that you are selecting the PIO mode supported by the IDE drive
being configured.
Available options are:
Auto
03
14
25
32Bit Mode
Hard disk drives connected to the SBC via the ISA Bus transfer data 16 bits at a time.
An IDE drive on the PCI Local Bus can use a 32-bit data path.
If the 32Bit Mode parameter is set to On, AMIBIOS enables 32-bit data transfers. If the
host controller does not support 32-bit transfer, this feature must be disabled.
Available options are:
Off
On
B
OOT SECTOR
V
IRUS PROTECTION
This option allows you to request AMIBIOS to issue a warning when any program or
virus issues a Disk Format command or attempts to write to the boot sector of the hard
disk drive.
The Setup screen displays the system option:
Boot Sector Virus Protection Disabled
Available options are:
Disabled
Enabled
If the Boot Sector Virus Protection option is set to Enabled, the following message
displays when a write is attempted to the boot sector.
Boot Sector Write!!! Possible VIRUS: Continue (Y/N)?