Intel SRCU31 Computer Hardware User Manual


 
Intel® Server RAID Controller U3-1 User’s Manual Rev 1.0 2-35
Advanced Installation Steps
b. During Windows NT installation install the following components:
—TCP/IP
— Microsoft Internet Information Server 2.0.
c. After the NT installation is complete, install the following components and software:
— Microsoft Windows NT 4.0 Service Pack 5 or greater (This will automatically upgrade
Internet Information Server 2.0 to Internet Information Server 3.0.).
— Microsoft Internet Explorer 4.00 or greater (recommended) or Netscape Navigator
4.08 or greater.
5. If your browser uses a proxy server, then configure your browser using the procedure in
Section B.6, “Browser Configuration During Initial Installation” on page B-5 andreturntothis
procedure. If you have not configured your browser to use a proxy server, then go to step 8.
6. Configure Microsoft Internet Information Server (IIS)
Warning: Due to added security in SRCU31, anonymous connections must be disabled in
Microsoft IIS in order to execute the SRCU31 configuration utility in NT. If anonymous
connections are allowed to IIS on the target server, then the following message will appear on
the web browser after launching the SRCU31 configuration utility shortcut:
Unable to open Driver
Could not open I
2
O Driver
To avoid the problem described above when attempting to run Storage Console, disable Allow
Anonymous connections to Microsoft IIS. Follow the directions below to disable Allow
Anonymous connections.
Note: If you need to use the World Wide Web service capabilities of Internet Information
Server 4.0 to publish a web site on a server using SRCU31, install IIS 4.0. Reconfigure IIS
using the IIS 4.0 instructions in Section 2.5.5, Configuring Microsoft Windows IIS 4.0.Return
to this procedure when completed.
If IIS 3.0 is installed on a FAT partition go to step 7. If you need to use IIS 4.0, reconfigure IIS
using the IIS 4.0 instructions in Section 2.5.5, Configuring Microsoft Windows IIS 4.0.Goto
step 8 when completed. If you are using Microsoft IIS 3.0 on an NTFS partition, proceed to
step 8.
7. Configuring Microsoft IIS 3.0
a. Start Internet Services Manager from the Microsoft Internet Server program group.
b. Double-click on the server name in the WWW Service row (top computer name).
c. Under the Service tabintheWWW Service Properties window clear the Allow Anonymous
checkbox in the Password Authentication section. See Figure 2-24.