Filter
Top Products
Intel® Server RAID Controller U3-1 User’s Manual Rev 1.0 2-39
Advanced Installation Steps
2.5.4.4 Installing Microsoft Windows NT Server 4.0 on a Pass-through Disk
or another Storage Device
This procedure installs Microsoft Windows NT Server 4.0 on a pass-through disk or another
storage device. It is typically used on a system where the operating system is on a disk not
controlled by SRCU31. Have all hardware and software on hand. See system requirements in
Section 2.5.4.2.
SRCU31 Hardware Installation
Install the hardware before continuing with this installation. See Section 2.5.2.3.
Intel Integrated RAID Software Installation
1. If you are installing Microsoft Windows NT Server on a Pass-through Disk go to step 2.Ifyou
are installing Microsoft Windows NT Server on another storage device, then go to step 3.
2. Create a pass-through disk. Once step a is completed, return to this procedure to install the
operating system.
a. Create a pass-through disk and select it as the boot device. Using the RAID Configuration
Utility (see “How to Invoke Advanced RCU” on page 2-19 for more information) create a
pass-through disk and select it as the boot device (see “Custom Configuration” on
page 2-12 for more information on creating a pass-through disk). The operating system
will be installed on this disk. You may choose to create more than one pass-through disk at
this time.
3. Run the latest virus scan on on any existing volumes and any downloaded diskettes used for
installation.
4. Install the following required software components. If you are installing Microsoft Windows
NT Server on a Pass-through Disk, go to step a. If you are installing Microsoft Windows NT
Server on another storage device, then ensure the CD-ROM drivers are detected during
installation and then go to step b.
a. Microsoft Windows NT Server 4.0
Select the scenario below (1 or 2) that matches your installation to complete the Microsoft
Windows NT SCSI diskette miniport driver installation.
Warning: The miniport driver is a temporary driver used for installation only. Once NT is running, you must
install the permanent RAID device drivers using the SRCU31 CD-ROM.
1. If you are installing NT with boot disks (booting from diskettes initially to setup NT),
during install let NT detect the storage devices in your system. When device detection is
complete, select S to specify additional storage devices, then select Other. Insert the
Microsoft Windows NT installation diskette in the floppy drive. Press Enter to select the
I
2
O Miniport Driver and continue with the NT installation. Go to step b.
2. If you are installing NT without boot disks, (for example, you are booting with the
NT Server CD-ROM), pressF6assoonasthebluescreenappears
to ensure that the
Microsoft Windows NT installation diskette can be loaded when specifying Other
Diskettes. Otherwise, the NT installation program will not load the I
2
O Miniport Driver
from the Microsoft Windows NT installation diskette. When device detection is complete,
select S to specify additional storage devices and then select Other. Insert the Microsoft
Windows NT installation diskette in the floppy drive. Press Enter to select the I
2
O
Miniport Driver and continue with the NT installation. Go to step b.
b. During Windows NT installation install the following components: