Intel SRCU31 Computer Hardware User Manual


 
Intel® Server RAID Controller U3-1 User’s Manual Rev 1.0 2-59
Advanced Installation Steps
5. NetWare will then ask for the size of the boot partition, you can either keep the default of
50MB or hit “Modify” to change the size to suit your needs. When you are done, select
“Continue”.
6. It will ask you confirm the boot partition creation. Select “Continue”. You will then press a key
to reboot.
7. When NetWare boots again, it will first format the newly created boot partition, and then start
loading files. During this initialization, you will see a white graphical NetWare logo screen.
8. It will eventually load a Welcome screen, asking you to verify the startup directory
(C:\NWSERVER). Hit <Alt> <F10> to exit the installation. At the console, type “Down”. The
installation exits to the boot drive prompt.
9. Insert the SRCU31 NetWare installation diskette into the A: drive. If your boot drive is C:,
then run NWUPDATE.BAT. If your boot drive is other than C:, then create an NWUPDATE
subdirectory and copy all the files from A:\DRIVERS into the NWUPDATE subdirectory.
10. Remove the diskette from the A: drive and reboot the server from the NetWare CD-ROM.
After booting you will be asked to Accept the License Agreement. Do so and then select
“Continue with Existing Partition”. You are now ready install NetWare 5 on the SRCU31
volume.
11. Continue with the NetWare installation as normal by following the screen prompts. Select the
Block Storage OSM when prompted.
12. Remove the NetWare CD-ROM from the CD-ROM drive and reboot the server and install
Support Pack 4 or higher. Once the server installation is completed, reboot the server.
13. Install the SRCU31 software (run the Intel Server RAID Controller U3-1 setup).
14. Run "NWCONFIG".
15. Select "Product Options", then "Install product not listed". It will tell you that it is going to
scan the A: drive for installation scripts. Ensure the "NetWare Installation" diskette is in the
floppy drive, hit <Enter> to continue.
16. A screen prompt will ask which components you wish to install. Select the following
components and hit <F10> to continue.
BKSTROSM.HAM
SCSIOSM.HAM
HTTP and Winsock Services
RAID Management Agents
The appropriate files are copied and the AUTOEXEC.NCF and STARTUP.NCF files are
modified as necessary.
17. After the installation is complete, reboot the server to load the new drivers.
18. See Section 4.3 in the “Using the Storage Console” chapter to customize your RAID volumes
using Storage Console.