Filter
Top Products
Chapter 1 — Using the CK30 Handheld Computer
22 CK30 Handheld Computer User’s Manual
When the CK30 successfully reads a bar code label, you hear
a high beep and the green Good Read light turns on briefly.
4 Release the Scan button.
Scanning With the 2D Area Imager
The CK30C may have the 2D area imager option instead of the
1D linear imager or laser scanner. The 2D imager provides the
ability to scan 2D bar code symbologies and supports omni-
directional (360°) scanning. Omni-directional scanning means
that you can position the CK30 in any orientation to scan a bar
code label. Using the 2D area imager is very similar to taking a
picture with a digital camera.
To scan a bar code label with the 2D area imager
1 Press I to turn on the CK30.
2 Point the scanner window at the bar code label and hold the
CK30 steady a few inches from the label.
3 Press the Scan button on the keypad or pull the trigger on a
handle and center the red aiming beam over the bar code
label.
The imager flashes repeatedly while it is trying to read a bar
code. The aiming beam is smaller when the imager is closer to
the bar code and larger when it is further away.