Filter
Top Products
Chapter 2 — Configuring the CK30
34 CK30 Handheld Computer User’s Manual
2 Press Enter to exit and save your changes through a cold
boot. Press Esc to exit without saving your changes through a
cold boot.
Configuring the CK30 by Scanning Bar Codes
You can change some of the configuration parameters of the
CK30 by scanning Code 39 or Code 93 bar code labels
containing configuration commands. This method is a fast and
easy way to change just a few configuration parameters on a
single CK30.
You can only change some of the configuration parameters by
scanning bar codes. To configure all of the configuration
parameters, use the Configuration Utility or send commands
through the network to your CK30.
You can print and scan the bar code labels from the CK30
Command Reference Manual or you can create your own bar
code labels. For help, see the CK30 Command Reference Manual.
You can also use Intermec’s EasySet software to print
configuration labels you can scan to change your configuration
settings. For more information, see the EasySet online help.
EasySet is available from the Intermec Data Capture web site.
For example, you can use the Beeper Volume configuration
command to adjust the beep volume of the CK30. Scan this bar
code label to set the volume to the lowest (quietest) level:
Beeper Volume Low
*$+BV1*
*$+BV1*