Filter
Top Products
Chapter 2 — Configuring the CK30
54 CK30 Handheld Computer User’s Manual
3 Choose Configuration Utility > Communications > 802.11
Radio > Security.
4 For Network Authentication, choose Open.
Intermec recommends using Open.
5 For Data Encryption, choose WEP.
6 For Network Key Setting, choose Enter Key and Index.
7 For Network Key Value, enter an ASCII key or a hex key that
is either 5 bytes or 13 bytes long depending on the capability
of the radio.
Set a 5-byte value for 64-bit WEP or a 13-byte value for 128-
bit WEP. Hex keys must be preceded by 0x and contain 5 or
13 hex pairs.
8 For Network Key Index, select the key you want to use for
data transmission.
9 Exit the Configuration Utility.
Disabling Security
If you choose not to use security with your WLAN, you need to
disable it on the CK30. By default, static WEP is enabled.
Intermec recommends that you always set security in your
network.
To disable security
1 For Network Authentication, choose Open or Shared.
2 For Data Encryption, choose Disabled.
Saving Your Configuration Changes to Flash Memory
If you want to save your configuration changes through a cold
boot, you need to save your changes to the flash memory. You
can save your changes to flash memory by:
• Using the Configuration Utility main menu.
• Scanning a bar code.
• Sending a reader command through the network.