Filter
Top Products
Chapter 2 — Configuring the CK30
44 CK30 Handheld Computer User’s Manual
The Intermec Gateway or DCS 30X translate UDP Plus packets
on the wireless network into TCP/IP packets on the wired
network and vice versa. The access point acts as a bridge to allow
communications between the wired network and the wireless
network.
To use wireless communications in a UDP Plus network
1 Configure these network parameters on each CK30 in the
network:
• Network Name (SSID)
• Controller IP Address
• IP Settings (if not using DHCP)
• Network Port
2 Configure the security. For help, see “Configuring Security”
on page 48.
You can configure the network parameters on the CK30 with
the Configuration Utility. For help, see “Configuring the CK30
With the Configuration Utility” on page 30.
Configuring Ethernet Communications
You can use the CK30 directly in an Ethernet network if you
have ordered the Ethernet option on your CK30A and you
insert it into an AD1 or AD2 Communications Dock. The
communications dock has an Ethernet connector that makes it
possible for the CK30 to communicate with your Ethernet
network.