Filter
Top Products
3.13 Other Modes
3-62
5
55
5
Press the ENTER key. A blinking question mark (?)
appears.
6
66
6
Select On or Off using the U or V key.
7
77
7
Press the ENTER key.
8
88
8
To exit the menu selection, press the MENU key.
3.13.8 Auto Continue Setting
When Auto Continue is enabled, the printer will automatically
print the next received data following a preset amount of time
passes after any one of the following errors occurs:
[
Memory overflow Press GO
]
[
Print overrun Press GO
]
[
KPDL error Press GO
]
[
File not found Press GO
]
[
RAM disk error Press GO
]
[
MemoryCard err Press GO
]
[
Hard disk err Press GO
]
[
Duplex disabled Press GO
]
[
Add Staple Press GO
]
[
Chad box full Press GO
].
If one of the above errors is caused by someone on a network
where the printer is being shared, for example, data sent from
another person will be printed after a preset amount of time.
The default Auto Continue setting is Off (disabled).
Note
For setting the auto continue recovery time,
see the next section.
1
11
1
Press the MENU key.
2
22
2
Press the U or V key repeatedly until Others >
appears.
3
33
3
Press the Z key
4
44
4
Press the U or V key repeatedly until Auto
Continue > appears.
5
55
5
Press the ENTER key. A blinking question mark (?)
appears.
6
66
6
Select On or Off using the U or V key.
7
77
7
Press the ENTER key.
8
88
8
To exit the menu selection, press the MENU key. The
display returns to Ready.
3.13.9 Setting the Auto Continue
Recovery Time
Follow the procedure given below to change the recovery
time for Auto Continue.
1
11
1
Press the MENU key.
2
22
2
Press the U or V key repeatedly until Others >
appears.
3
33
3
Press the Z key.
4
44
4
Press the U or V key repeatedly until Auto
Continue Mode > appears.
5
55
5
Press the Z key and display >> Auto Continue
Timer. The default setting is 30 seconds.
6
66
6
Press the ENTER key. A blinking cursor (_) appears.
>Buzzer
? Off
Others >
>Auto Continue >
Mode Off
>Auto Continue
Mode ? Off
Others >
>Auto Continue >
Mode On
>>Auto Continue
Timer 030sec.
>>Auto Continue
Timer 030
sec.