Kyocera C8026N Printer User Manual


 
2.1 General
2-2
2.1 General
Your Ecosys Color printer is designed for high-grade bond (copy) paper, like the type
widely used for ordinary xerographic copiers. It will also support other types of paper as
long as they meet the standards explained in this chapter.
Selecting the right paper is very important. Use of unsuitable paper can cause paper jams,
misfeed, curling, poor print quality, and even worse, printer damage. This chapter shows
you how to use your printer in a way that will ensure efficient, error-free printing and
minimal printer damage. This practice will increase your office productivity.
Note
Kyocera Mita will not be liable for any problems that may occur if you use paper that
does not meet these standards.
2.1.1 Available paper types
The FS-C8026N can use almost any type of printer paper. These printers accept paper used
for xerographic copiers as well.
Paper comes in three generic grades: economy, standard, and premium. The grades are
determined by how easily the paper can pass through the printer. This depends on the
smoothness, size, moisture content, and cutting of the paper. The higher the grade, the less
risk of problems (such as paper jams), and higher the print quality.
The differences in paper characteristics of different paper makers also affect the printer
performance. High-performance printers can produce high-quality results only when the
right types of paper are selected. Low-priced paper is not always economical, especially if it
ends up causing frequent printing problems.
Paper of the different grades is available in basis weights (explained later). The recommended
basis weights of paper for the printers are 16, 20, and 24 pounds. When expressed in grams
per square meter, the recommended basis weights range from 60 to 105 g/m².
2.1.2 Paper specifications
Table 2-1 summarizes the basic paper specifications. Details are given on the subsequent
pages.
Item Values
Weight (basis weight) Cassette: 60 to 105 g/m² (16 to 28 lb/ream)
MP tray: 60 to 220 g/m² (16 to 58 lb/ream)
Thickness 0.086 to 0.110 mm (3.4 to 4.3 mils)
Dimensions See Table 2-2.
Dimensional accuracy
±
0.7 mm (
±
0.0276 inches)
Squareness of corners
90
±
0.2 °
Moisture content 4 to 6 %
Table 2-1