Filter
Top Products
A.2 Expansion Memory Modules
A-3
A.2 Expansion Memory Modules
Expanding printer memory lets you print more complex data,
and also makes printing faster. The FS-C8026N printer has a
single memory expansion slot, which you can use to expand
memory up to a maximum of 512MB.
Note
Only an authorized Kyocera Mita dealer should
install the expansion memory. Kyocera Mita
shall not be liable for any damages caused by
improper installation of expansion memory.
To expand memory up to 512MB, remove the 128MB
memory module that is installed at the factory and install two
256MB memory modules.
Precautions on handling the printer's main
controller board and memory modules
• To protect electronic parts, discharge static electricity
from your body by touching a water pipe (faucet) or
other large metal object before handling the memory
modules. Or, wear an antistatic wrist strap, if possible,
when you install the memory modules.
• Always hold the main controller board or a memory
module by its edges as shown below to avoid damaging
electronic parts.
Figure A-2
A.2.1 Installing the Memory Modules
1
11
1
Power off the printer and unplug the printer power
cord.
2
22
2
Unscrew two screws at the back of the main controller
board.
Figure A-3
3
33
3
Pull out the main controller board gently.
Figure A-4
4
44
4
Push out the clamps on both ends of the memory
socket on the main controller board.
Figure A-5
Yes
No
Main controller board
Clamps