Filter
Top Products
4.3 Error Messages
4-11
Storage error codes
Hard disk errors
Memory card errors
RAM disk errors
Code Meaning
01 Hard disk format error. If this error recurs even if the power has been turned off and then on,
reformat the hard disk.
02 The disk system is not installed. Recheck the requirements for using the system and the
devices.
04 There is no available hard disk space. Delete unnecessary files, etc., in order to free up space.
06 There is no memory available to the hard disk system. Increase the available memory.
10 Formatting is not possible because host data is being spooled on the hard disk. Wait until the
hard disk is ready, and then format.
85 VMB: Alias error. The alias setting was lost, or the virtual tray corresponding to the alias
does not exist. Set the alias again.
97 The number of permanent code jobs that can be stored reached the limit value, and no more
can be saved. Either delete some unnecessary jobs, etc., or increase the limit.
98 An unreadable page was found in a job (The job is damaged.).
99 A print job for the specified ID does not exist in the hard disk.
Table 4-4
Code Meaning
01 The printer does not support the memory card inserted. The memory card must meet the
requirements described in A.3.1 Memory Card on page -5.
02 The memory card is not installed.
04 The memory card is full and cannot hold further data. Purge unnecessary files or use a new
memory card.
06 Insufficient printer memory to support the memory card system. Expand printer memory.
Table 4-5
Code Meaning
01 Format error. Try turning the power off and on again.
02 RAM disk mode is Off. Turn RAM disk mode On from the operator panel.
04 No disk space. Purge unnecessary files.
06 Insufficient printer memory to support the RAM disk system. Expand printer memory.
Table 4-6