Filter
Top Products
4. Gently lower the heat sink on the microprocessor.
5. Install the heat sink on the microprocessor.
Attention: Do not touch the thermal material on the bottom of the heat sink. Touching the thermal
material will contaminate it. If the thermal material on the microprocessor or heat sink becomes
contaminated, contact your service technician.
a. Make sure that the thermal material is still on the bottom of the heat sink; then, align the heat sink
so that the arrows on the label point toward the DIMMs and place the heat sink on top of the
microprocessor, thermal material side down.
b. Align the screw holes 1 on the heat sink with the holes on the system board 3 Following is an
illustration of the heat sink orientation.
Heatsink
Orientation
DIMMs
DIMMs
c. Tighten the screws with a screwdriver, alternating among the screws until they are tight. If
possible, each screw should be rotated two full rotations at a time. Repeat until the screws are
tight. Do not overtighten the screws by using excessive force.
142 ThinkServer ThinkServer RS210, Types 6531, 6532, 6533, and 6534: Hardware Maintenance Manual