Filter
Top Products
Removing the optical drive
Attention:
Do not open your server or attempt any repair before reading and understanding the Safety Information and the
Warranty and Support Information on the ThinkServer Documentation DVD that came with your product, and
“Guidelines” on page 39
. To obtain a copy of the publications, go to:
http://www.lenovo.com/support
This section provides instructions on how to remove the optical drive.
To remove the optical drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 43.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on page 45.
4. Disconnect the signal cable and the power cable from the rear of the optical drive.
5. Press the optical drive retainers 1 on both sides of the optical drive and slide the optical drive out of
the front of the server.
Figure 20. Removing the optical drive
Chapter 5. Replacing FRUs 53