Filter
Top Products
CALIBRATION AND TROUBLESHOOTING
Error Messages
102 LDX-3232
CHAPTER 6
Error Code Explanation
E-203 Security violation, command is not available without clearance
E-205 <PROGRAM DATA> is not a Boolean value or word
E-207 <PROGRAM DATA> will not convert to an unsigned 16-bit value
E-209 <PROGRAM DATA> will not convert to an unsigned 32-bit value
E-210 <PROGRAM DATA> will not convert to a floating point value
E-211 <PROGRAM DATA> will not convert to a character value
E-213 <PROGRAM DATA> is incorrect block data length
E-214 <PROGRAM DATA> length exceeds maximum
E-302 Query error; device was addressed to talk, but GPIB controller failed to read all of the
<RESPONSE MESSAGE>
E-501 LASER interlock disabled output
E-503 LASER open circuit disabled output
E-504 LASER current limit disabled output
E-505 LASER voltage limit disabled output
E-507 LASER power limit disabled output
E-510 LASER out of tolerance disabled output
E-511 LASER control error disabled output
E-512 Analog section status is all 1’s or all 0’s (power down)
E-513 Serial EEPROM checksum error
E-515 Laser output must be off to change ranges
E-516 Incorrect configuration for calibration sequence to start
E-519 Setting a measurement is only valid during the calibration phase for that measurement;
user has tried to calibrate a measurement without first entering the required calibration
mode.