Filter
Top Products
REMOTE OPERATION
Error Messages
34 LDX-3232
CHAPTER 3
Error Code Explanation
E-501 LASER interlock disabled output
E-503 LASER open circuit disabled output
E-504 LASER current limit disabled output
E-505 LASER voltage limit disabled output
E-507 LASER power limit disabled output
E-510 LASER out of tolerance disabled output
E-511 LASER control error disabled output
E-512 Analog section status is all 1’s or all 0’s (power down)
E-513 Serial EEPROM checksum error
E-515 Laser output must be off to change ranges
E-516 Incorrect configuration for calibration sequence to start
E-519 Setting a measurement is only valid during the calibration phase for that measurement;
user has tried to calibrate a measurement without first entering the required calibration
mode.