Filter
Top Products
COMMAND REFERENCE
LDX-3232 Device-Dependent Command Reference
66 LDX-3232
CHAPTER 4
The LASer:LIMit:MDP command sets the laser monitor photodiode power limit value.
Syntax Diagram
Parameters An <nrf value> that represents the laser monitor photodiode power limit in mW.
Notes When constant MDP mode is used, the output level is limited only by the LIM Ix value.
Exceeding the powere limit will either cause the output to shut off (default) or generate a
warning (see LAS:ENAB:OUTOFF command).
Examples "LAS:LIM:MDP 10" -action: sets the laser output power limit to a value that corresponds
to producing 10.00 mW of photodiode feedback (optical) power.
"Las:Limit:MDp 5" -action: sets the laser output power limit to a value that corresponds to
producing 5.00 mW of photodiode feedback (optical) power.
The LASer:LIMit:MDP? query returns the value of the laser monitor photodiode power
limit.
Syntax Diagram
- where the response is the LASER power limit setting.
Notes The (LASER) MDP limit is in effect for both laser output current ranges.
The MDP limit is not in effect when CALMD=0. In this case, the monitor current
measurement is not converted to power.
Examples "LAS:LIM:MDP?" -response: 3.0, means the monitor photodiode power limit is set to
3.0 mW.
":LAS:Limit:MDP?" -response: 10.0, means the monitor photodiode power limit is set to
10.0 mW.
LASer:LIMit:MDP
FRONT PANEL
REMOTE
LASer:LIMit:MDP?
FRONT PANEL
REMOTE
:
LAS
: :
LIM
MDP
P
<white
space>
<nrf
value>
:
LAS
:
LIM
P
:
?
MDP