Filter
Top Products
COMMAND REFERENCE
LDX-3232 Device-Dependent Command Reference
62 LDX-3232
CHAPTER 4
The LASer:LDI command sets the laser control current.
Syntax Diagram
Parameters An <nrf value> that represents the (laser) output current in mA.
Notes setpoint is the same for both low and high bandwidth output modes.
Examples "Las:LDI 400" -action: sets the laser output current to 400.00 mA.
"LAS:ldi 100" -action: sets the laser output current to 100.0 mA.
The LASer:LDI? query returns the value of the measured laser current.
Syntax Diagram
- where the response is the most recent laser current measurement.
Notes Response is the measured laser output current for either low or high bandwidth modes.
This measurement is updated approximately once every 600 ms.
Examples "LAS:ldi?" -response: 30.0, means the measured laser output current is 30.0 mA.
"Laser:LDI?" -response: 100.0, means the measured laser output current is 100.0 mA.
LASer:LDI
FRONT PANEL
REMOTE
LASer:LDI?
FRONT PANEL
REMOTE
<white
space>
<nrf
value>
:
:
I
LDI
LAS
:
LAS
I
:
?
LDI