Filter
Top Products
COMMAND REFERENCE
LDX-3232 Device-Dependent Command Reference
58 LDX-3232
CHAPTER 4
The LASer:ENABle:OUTOFF command sets the status outoff enable register of the
LASER operations (things that will turn the LASER output off).
Syntax Diagram
Parameters An <nrf value> whose sum represents the enabled bits:
Notes The enabled LASER outoff bits can be read by using the LASer:ENABle:OUTOFF?
query.
The enable registers normally retain their values at power-up (as they were at power-
down) unless the power-on status clear flag is set true (for more information see the
*PSC definition, in the GPIB-IEEE488 specification).
The factory default value for this register is #B0000100000001000, #H808, or 2056
decimal.
Examples "LAS:ENAB:OUTOFF 9" -action: enables the LASER status outoff register so that Power
limit and LASER current limit conditions will cause the LASER output to be turned off.
"Las:Enab:Outoff #HE0B" -action: enables the LASER status outoff register so that any
or all of the above conditions will cause the LASER output to be turned off.
LASer:ENABle:OUTOFF
FRONT PANEL
REMOTE
1 LASER Current Limit 256 N/A
2 LASER Voltage Limit 512 Output is out of tolerance*
4 N/A 1024 N/A
8 Power limit (with output on) 2048 N/A
16 N/A 4096 N/A
32 N/A 8192 N/A
64 N/A 16384 N/A
128 N/A 32768 N/A
:
LAS
<white
space>
<nrf
value>
:
ENAB
:
OUTOFF