Filter
Top Products
12
CHAPTER 1Installation
3. Setting-Up
3
- Before opening the optional packages or handling the options, briefly touch the metal part of the printer to
remove any electrostatic charge from your body.
- When options are taken out of their conductive bags or off their mats, hold them by their edges to avoid touching the
terminals or the patterned surfaces.
- When the Controller board is taken out of the printer, hold it by the edges to avoid touching the terminals or the
patterned surfaces.
- After removing the options or Controller board, be sure to place it on an anti-static mat or a piece of aluminum foil.
CAUTION
-
Remove the four screws that secure the controller
board on the back of the printer.
- Slide out the controller board.
NOTE
-
When the Controller board is taken out of the
printer, hold it by the edges to avoid touching
the terminals or the patterned surfaces.
-
After removing the options or Controller board,
be sure to place it on an anti-static mat or a
piece of aluminum foil.
4
1
-
Turn the printer OFF.
Power Switch
Adobe PostScript ROM SIMM (Option) Setting-Up
PRECAUTION
-
This printer is equipped with a socket for the installation of an Adobe PostScript ROM SIMM. When the printer is
equipped with an Adobe PostScript ROM SIMM, it can function as a PostScript printer.
2
-
Disconnect the cable from the interface connector
(Parallel or Serial) or network connector
(10BASE-T or 10BASE-2) on the back of the
printer.