Filter
Top Products
77
Troubleshooting
CHAPTER 5
LCD Message Description Action
REMOVED
XXXXX TONER
The toner cartridge isn’t present. Mount the Toner Cartridge.
☞
p. 48
REMOVED
DRUM UNIT
The drum cartridge is missing. Mount the Drum Cartridge.
☞
p. 56
REMOVED
WASTE BOTTLE
The waste toner bottle is missing. Mount the Waste Bottle.
☞
p. 56
REMOVED
OILING ROLLER
The Oiling Roller or fusing unit is
missing.
Mount the Oiling Roller.
☞
p. 56
Mount the Fusing Unit.
☞
p. 62
WARNING
COVER OPEN
The front cover or the rear cover of
the printer were not closed cor-
rectly.
Close the Front Cover.
☞
p. 18
Close the Rear Cover.
☞
p. 18
WARNING
PAPER JAM 1
A paper jam occurred near the
paper take-up section.
Remove the sheet of paper misfed.
For details, see “When a Paper Misfeed has
Occurred.”
☞
p. 80
WARNING
PAPER JAM2
A paper jam occurred between the
paper take-up section and the fus-
ing section.
WARNING
PAPER JAM3
A paper jam occurred between the
fusing section and the paper exit
section.
RESET TO SAVE
During the printing cycle, one or
more printer settings were changed.
If you want the current printing cycle to use the
new setting, stop the printing cycle using the JOB
& MEMORY function.
When printing has stopped, initiate a new printing
cycle.
☞
pp. 36, 38, 40
If you do not want the current printing cycle to
use the new setting, press the Proceed key to
resume the current printing cycle.
The new setting will be used in the next printing
cycle.
CONTEXT SAVE
CHANGE
The setting for PCL CONTEXT
SAVING or PS CONTEXT SAV-
ING has been changed.
Press the Proceed key. When “READY” appears
on the display, the new setting for CONTEXT
SAVING has been entered. Please refer to MEM-
ORY MENU in Chapter 3 for details.
☞
p. 45
.
MEMORY OVERFLOW
The printer has received more data
than can be fit into its internal
memory.
Press the Proceed key.
The printer returns to the On-line state.
Run the print cycle again.
BUFFER FULL
A buffer full error occurred .
DATA TOO COMPLEX
The data sent can’t be processed
because it is too complex.
2. A Problem Exists in the Preparation Stage and During a Print Cycle