Filter
Top Products
42
Œ
CHAPTER 3Changing the Printer Settings
9. TRAY3 MEDIA
- The
TRAY 3 (Third Cassette)
media type is selected. The factory default media type is
PLAIN PAPER
.
- When
TRANSPARENCY
and
FULL COLOR
(PRINT MODE
☞
p. 43) are both selected, the engine slows the machine throughput to
one-third so that it can saturate the
toner application.
- When
THICK PAPER
is selected, the engine slows the machine throughput to one-third so that it can saturate the
toner application.
- Notice that
TRAY3 MEDIA
does not appear unless the
250-Sheet Third Cassette
is physically installed under the printer.
10. ORIENTATION
- The default direction of the printed page is selected.
PORTRAIT
or
LANDSCAPE
can be selected.
- The factory default direction is
PORTRAIT
.
11. FORM LENGTH
- The Number of lines per page is selected. The settings goes through a loop from
5
to
128
and then back to
5
again.
- European models having
A4
will have
64 lines
as the default
whereas the U.S. and
other North American models having
LETTER
will have
60 lines
as default .
-
When the Up or Down key is pressed continuously, the
setting is incremented/ decremented faster.
CONFIG MENU is a group that configures the printer environment under normal use (excluding the net-
work settings).
1. PERSONALITY
- The default
personality
is selected (Automatic, PCL5C, PostScript). When the PostScript SIMM ROM is not installed, the menu
Settings "
POSTSCRIPT
" and "
AUTOMATIC
" do not appear.
- The factory default is
AUTOMATIC
. (When the PostScript SIMM ROM is not installed, the factory default is
PCL
)
2. AUTO CONTINUE
- The
Auto Continue
setting is selected.
When Auto Continue is on, recoverable error messages appear on the LCD for only
30 seconds. Then, the
READY
message reappears and the printer resumes printing.
- When "
AUTO CONTINUE
" is "
ON
", printing will continue from the message "
LOAD PAPER SIZE
" as if the
PROCEED
key is
pressed.
- The factory default is
ON
.
3. I/O TIMEOUT
- The period from the end of the print job to the idle state is selected. After the time has elapsed, the controller frees that port.
- The settings are
5 SECONDS
,
15 SECONDS
,
30 SECONDS
,
1 MINUTE
,
3 MINUTES
and
OFF
.
- The factory default is
15 SECONDS
.
4. POWER SAVE
- The default
power save
of the printer is selected.
- The controller sends the power-down command to the printer when the idle time has passed. If data exists in memory, the printer does
not
activate the power save mode.
- The settings are
15 MINUTES
,
30 MINUTES
,
60 MINUTES
and
OFF
.
- The factory default is
60 MINUTES
.
3. PRINT MENU
3. Outline of the MENU Utilities
4. CONFIG MENU