Mitsubishi Electronics CP900E Printer User Manual


 
14
CONNECTION WITH RGB ANALOG SIGNAL EQUIPMENT
Make sure to turn off the power before setting.
(EXAMPLE)
This unit is designed to accept RGB video at the PAL frame rate,
nominally 15.75kHz horizontal and 50Hz at vertical.
Connect this unit and RGB analog signal equipment
with a BNC cable.
Set the RGB IMPEDANCE switch to 75/HIGH. Set
the sync. signal IMPEDANCE switch to HIGH.
IMPEDANCE SWITCH
RGB 75/HIGH Power ON: 75 termination
Power OFF: No termination
75 Power ON/OFF: 75 termination
HIGH Power ON/OFF: High impedance - No termination
SYNC 75/HIGH Power ON: 75 termination
Power OFF: No termination
75 Power ON/OFF: 75 termination
HIGH Power ON/OFF: High impedance - No termination
The normal settings are: RGB 75/HIGH and SYNC : HIGH
When the printer is between the RGB video source and the monitor the
normal settings should be used. If the 75 termination is not set correctly,
the video will be either too dark or too bright.
75
75/HIGH
HIGH
IMPEDANCE
RGB
75
75/HIGH
HIGH
SYNC
Impedance switch
for RGB analog signal
Impedance switch
for sync.signal
REMOTE
RS-232C
S-VIDEO IN
S-VIDEO OUT
R
G/G+SYNC B Y/SYNC
IN
VIDEO
75
75/HIGH
AC LINE
OUT
75/HIGH
75
75
75
75
HIGH
HIGH
HIGH
HIGH
ON
OFF
POWER
HIGH
IMPEDANCE
RGB
75
75/HIGH
HIGH
SYNC
RECORD
REPLAY
10 KEY
RED
GREEN
GREEN
BLUE
BLUE
CONTRAST
BRIGHTNESS
BRIGHTNESS
SCAN SPEED
RESET
RESET
WHITE
BALANCE
SCAN START
x
c
v
bn
m,.
/
z
POWER
ON OFF
R
G/G+SYNC.
B
H+V-SYNC.
To RGB analog output
terminals
R
G/G+SYNC.
B
H+V-SYNC.
To RGB analog
input terminals ( )
VCP
RGB analog signal equipment
Connection is not
required for
SYNC ON G
CONNECTIONS