Filter
Top Products
47
CONNECTIONS
PRINTING
PRECAUTIONS FEATURES
PREPARATION
OTHERS
TROUBLE-
SHOOTING
ADJUSTMENTS
PAPER HOLD Sets to hold the printed paper or not.
OFF Printed paper is cut and released.
ON Printed paper is held at the print outlet after cut. Pull the paper out
when necessary.
• When selecting THERMAL : ON, this menu changes to AUTO CUT.
• It is recommended not to leave the printed paper holding at the print outlet.
Some malfunction may occur.
• Do not turn off the power while holding paper.
• When PAPER HOLD is set to ON, MENU button and COLOR ADJ button on the
remote control unit are not avilable.
AUTO CUT Selects cutting the printed thermal paper automatically or not.
ON Cuts the printed thermal paper automatically.
OFF Does not cut the thermal paper. Press MEMORY button while
pressing MONITOR button.
• This menu is displayed only when THERMAL : ON is selected.
INIT PROG (Initialize program)
ALL Mode to initialize the program in MAIN MENU and SERVICE
MENU.
MAIN Mode to initialize the program in MAIN MENU.
SERVICE Mode to initialize the program in SERVICE MENU.
INITIALIZE
OFF Does not initialize.
GO[SET] Starts initializing. When SET button is pressed, initializing starts.
PAPER
HOLD
AUTO
CUT
MARGIN
CUT
With ink cassette
THERMAL
OFF
OFF
OFF
OFF
ON
ON
OFF
OFF
ON
ON
Not displayed
Not displayed
OFF
ON
OFF
ON
OFF
OFF
Normal colour print
Normal colour print with Margin cut
Normal colour print with Paper hold
Normal colour print with Paper hold after margin cut
Printing is not available.
REMOVE CASS TML *2
Not displayed
Not displayed
Not displayed
Not displayed
ON
OFF
Setting and type of print paper / Print result
Without ink cassette
With ink cassette
Without ink cassette
Printing is not
available.
CHECK CASSETTE
*1
Does not print
correctly.
*3
Printing is not
available.
CHECK CASSETTE
*1
Does not print
correctly.
*4
Printing is not
available.
REMOVE CASS TML
*2
Cuts after thermal
printing
Does not cut after
thermal printing
Type of print paper
Setting
Colour print paper
Monochrome thermal paper
*
1,
*
2 This error is displayed when turning the power on, and closing the door.
*
3 In this case, remove the thermal paper and install the colour print paper.
*
4 In this case, remove the colour print paper and install the thermal paper.
NOTE
• When setting THERMAL to OFF after thermal printing with setting AUTO CUT to
OFF, “PUSH FEED&CUT5” is displayed on the monitor and LCD. In this case,
press MEMORY button with holding MONITOR button to cut the printed paper.
• When selecting AUTO CUT : OFF, make sure to cut the printed paper before turning
off the power.
GAMMA ADJ INIT [CLEAR]
COLOR ALL/EACH
<SELECT R/G/B>
Hi 0
Mid 0
Low 0
POINT 64 128 192
GAMMA ADJ Gamma level setting display
INIT:[CLEAR] Initializes each setting.
COLOR Selects the adjusting gamma level.
ALL Adjusting gamma level for all colours.
EACH Adjusting gamma level for each colour of R, G, B.
SELECT Is displayed when selecting “EACH” in COLOR.
R Adjusting gamma level for red.
G Adjusting gamma level for green.
B Adjusting gamma level for blue.
Changing gamma curve:
Use the , buttons on the remote control unit to select the Hi/Mid/Low gamma
point to set.
Also Use , buttons to input setting level.