55
CONNECTIONS
PRINTING
ADJUSTMENTS
PRECAUTIONS FEATURES
PREPARATION
OTHERS
TROUBLE-
SHOOTING
BEFORE CALLING FOR SERVICE
Use the following troubleshooting chart to try to resolve any apparent defect in operation. If you are unable to resolve the
problem, unplug the power cord and contact your dealer.
Symptom Check and Remedy
No power Is the power cord plug disconnected from the outlet?
(when POWER lamp does not illuminate) →Connect the power cord plug to the outlet firmly.
After tuning the power off, wait for approx. 2 minutes. Then turn on the
power.
No image appears on the monitor. Are the IN SYNC, the OUT SYNC and the RGB SOG OUT set correctly?
→Check the current setting. Refer to pages 11-16.
Are the video signal and sync. signal inputted to this unit?
→Check the connection. Refer to pages 11-16.
Is the input signal on the menu screen (INPUT : VIDEO, S-VIDEO, RGB)
selected correctly?
→Check the current setting. Refer to pages 22-23.
Is the image stored in memory displayed on the monitor screen?
→Press MONITOR button to display the source image (LIVE).
The image on the monitor screen vibrates Are the sync. polarity of the monitor (OUT SYNC: NEGA POSI), the output
when characters are indicated on the monitor level of the sync. signal (OUTPUT SYNC) and the RGB output sync. signal
screen or LIVE SEL is set to “DIG”. (RGB SOG OUT) set correctly?
Refer to page 49. →Check the current setting. Refer to pages 11-16.
The image is not stored in memory. Are the images being printed with full memorized memory page?
→Press the CLEAR button on the remote control unit after printing.
Then, store the image in the memory again.
Is the memory full in the status of “INCREMENT : OFF” or “AUTO CLEAR :
OFF”?
→Store the image in the memory after pressing the CLEAR button on the
remote control unit.
(According to the setting conditions, the image can be stored in the
memory by setting INCREMENT to “PART” or “PAGE”, AUTO CLEAR to
“AFTER PRN” or pressing the PRINT button.)
Is the memory full in the status of “MEM & STOP : ON”?
→Press CLEAR button on the remote control, and store the image again.
The image is not printed. Is the image stored in memory?
→Confirm that the image is stored in memory.
Is the print paper or ink sheet used up?
→Check the status.
Is the printing mechanism set correctly?
→Set the printing mechanism correctly.