44
ADJUSTMENTS & SETTINGS (MAIN MENU)
Repeat steps to to complete a comment.
• Skip if you do not change the cursor position.
• Only one comment can be stored regardless of the program number you chose in
SAVE PRG. Same comment will be stored in PRG.1 through PRG3. Different
comments cannot be stored in each program.
• When printing in FIELD mode, the comment is a little lower in quality.
MEMORY POSITION Memory and Position setting display
• The print area settings made with this menu can be memorized as a user program
setting.
LINE Selects whether showing a frame of print area or not.
OFF A frame of print area is not shown.
ON A frame of print area is shown.
• When LINE is set to “ON”, the monitor colour may be changed, or the image may
become unstable horizontally, depending on the H-POSI setting. In this case, set
LINE to “OFF”.
• When the frame becomes over the setting area, the frame colour turns black.
• The frame is not displayed on the memory image.
H-POSI Changes the horizontal start position of input signal
The whole data image can be moved horizontally by changing the
setting number.
Setting area -8 ~ +8
• When setting minus value too large, the right side of the memory image is clipped
on the monitor. However, it is printed normally.
V-POSI Changes the vertical start position of input signal
The whole data image can be moved vertically by changing the setting
number.
Setting area -10 ~ 0
H-START (H-Position)
Sets H-Position to special signal timing. Select “FRONT” when the
image is unbalanced and cannot be corrected by H-POSI on basic
printing. When selecting FRONT, AFC in SERVICE MENU does not
work and the top part of the printing image may curved during VTR
special play back.
NOR(Normal) When inputting PAL input signal
FRONT When inputting special input signal
MEMORY POSITION
LINE OFF/ON
H-POSI 0
V-POSI 0
H-START NOR/FRONT
H-POSI
V-POSI
+
+
LINE