Filter
Top Products
NE-4100 Series User’s Manual Web Console Configuration
6-5
Time server
Setting Factory Default Necessity
IP or domain address
(E.g., 192.168.1.1, time.stdtime.gov.tw, or
time.nist.gov)
None Optional
NE-4100 Series modules use SNTP (RFC-1769) for auto time calibration.
Enter the Time Server IP address or domain address. When the Time Server IP address is provided,
the module will request time information from the Time Server every 10 minutes.
Console
Web console, Telnet console
Setting Factory Default Necessity
Enable or Disable Enable Required
The web console and Telnet console can be disabled for security reasons. In some cases, you may
want to disable one or both of these console utilities as an extra precaution to prevent unauthorized
users from accessing the module. The factory default for both web console and Telnet console is
Enable.
ATTENTION
If you disable both the web console and Telnet console, you can still use the serial console or
Network Enabler Administrator to configure the module.
Network Settings
Note: “Serial Command Mode” is supported in firmware version 3.0 and above.
You must assign a valid IP address to the module before it will work in your network environment.
Your network system administrator should provide you with an IP address and related settings for
your network. The IP address must be unique within the network; otherwise the module will not
have a valid connection to the network. First time users can refer to
Chapter 5 - Initial IP Address
Configuration for more information.