Filter
Top Products
NE-4100 Series User’s Manual Network Enabler Administrator
7-21
Serial Parameters
In the Serial Parameters tab, you may configure the selected module’s baud rate, parity, data bits,
stop bits, and flow control. The parameters shown below are the default settings.
Enable and Disable
Enable and Disable are used to activate or deactivate the selected module’s COM mapping
settings. Note that this menu may also be opened by right-clicking COM Mapping in the
navigation panel or by right-clicking the desired module. COM port mappings may be individually
enabled or disabled.
Once a module’s COM mappings have been enabled, the Real COM driver will operate
independently of Network Enabler Administrator. The mappings will be active whether or not
Network Enabler Administrator is open.
Apply and Discard Change
Apply Change and Discard Change are used to save or delete any changes COM mapping
settings. Select Apply Change in the COM Mapping context menu to save any changes made to
the COM mappings; select Discard Change to undo any changes that were made to the COM
mappings. Note that this menu may also be opened by right-clicking COM Mapping in the
navigation panel or by right-clicking the desired module.
Import and Export COM Mapping
Import COM Mapping and Export COM Mapping are used to save and load the COM
mappings for the Select Import COM Mapping in the COM Mapping context menu to load
settings into the selected module from an exported file; select Export COM mapping to save the
current settings for the selected module to a text file. Note that this menu may also be opened by
right-clicking COM Mapping in the navigation panel or by right-clicking the desired module.
IP Address Report Functions
IP Address Report functions are used to view IP address reports from appropriately configured
modules. When monitoring is activated, Network Enabler Administrator listens for IP address
reports on a UDP port number, which may be configured under Settings in the IP Address Report
context menu. Any IP address reports received at this port number will be displayed in the window.
Select Go to begin monitoring for IP address reports, Stop to cease monitoring, and Clear to clear
the current display of reports.