Filter
Top Products
NE-4100 Series User’s Manual Network Enabler Administrator
7-10
3. After the processing is done, the following window will open.
Note: “Serial Command Mode” is supported in firmware version 3.0 and above.
The module’s parameters are divided into ten tabs—Basic, Network, Serial, Operating
Mode, Accessible IPs, Auto Warning, IP Address Report, Password, Digital IO, and
Serial CMD. To make changes to any settings, the Modify box must be checked. The
changes will be made effective after you click OK, which will save all changes and restart the
module. Please refer to
Chapter 6 for descriptions of each parameter.
ATTENTION
You may simultaneously modify the configurations of multiple modules as long as the modules
are all the same model. To select multiple modules in the module list, hold down the Ctrl key
while selecting the desired modules in the Configuration window, or hold down the Shift key to
select a group of modules.